Distribution & Access For Publication Downloads News About Us Contact Us
Paper Titles
Preface
Effect of Ash-Slag Mix and Polypropylene Fiber on the Performances of Concrete Composite
p.1
Comparative Assessment of Effectiveness of Calcium Silicate Dispersions Produced Using Sucrose and Lactose as Components of Composite Cement Binder
p.11
Practical Application of the Similarity Law of Structures in the Reconstruction of the Surface Layer of Bricks
p.21
Мineral Powders Dispersion Degree Effect on the Properties of the Cementing Alkaline System
p.31
Effect of Mixing Procedure and Chemical Composition on Physical and Mechanical Performance of Geopolymers
p.41
Effective Application of 3D Additive Technologies for Creation of Construction Compositions Using Technogenic Raw Materials
p.51
Effects of Calcination Temperature and Time on the Physical-Chemical Efficiency of Thermally Activated Clays in Cement Systems
p.61
The Method of Creating and Measuring the Printability of Fine-Grained Concrete
p.71

Comparative Assessment of Effectiveness of Calcium Silicate Dispersions Produced Using Sucrose and Lactose as Components of Composite Cement Binder

Article Preview

Abstract:

Silicate micro- and nano-additives are multifunctional in relation to cement systems. Their application can solve a wide range of technological problems while maintaining the economic efficiency of technical solutions. The effect of silicate additives and fillers is determined by their level of dispersion, due to which the technologies for producing nano- and submicro-sized dispersed materials are being developed. The combination of mechanochemical synthesis of modified calcium hydrosilicates with subsequent thermolysis makes it possible to produce calcium silicate dispersions (SCD), which differ in polymodality of the fractional composition including submicro (10–7–10–6 m) and microdimensional (≥10–6 m) modes. The main element of the technology is the use of modifying carbohydrate, which acts as a stabilizer of hydrated phases of silicates. A comparative study of SCD produced using sucrose (sSCD) and lactose (lSCD) revealed the effect of these carbohydrates on the properties of sSCD and lSCD, as well as their effectiveness as a component of cementitious composite binder. It was found that the level of adsorption of modifying carbohydrate determines the physical properties of SCD (granulometry, specific surface area). The relatively high residual content of free sucrose (0.24%) in the composition of sSCD prevents the consolidation of silicates nanoparticles formed during the thermolysis, causes a high content of submicro sized fractions and a high specific surface area with sSCD (26.3 ± 0.7 m2/g). Lactose is absorbed by the silicate phase; the residual content of free lactose does not exceed 0.028% of lSCD. The low content of stabilizing carbohydrate contributes to the development of nanoparticle consolidation, a decrease in the specific surface area of lSCD to 13.0 ± 0.2 m2/g and content of submicrosized fractions. The residual content of free carbohydrates and particle size characteristics of sSCD and lSCD determine the nature of their influence on Cement-SCD-based concrete setting and hardening. The presence of residual sucrose in the composition of sSCD and fine fractions determines the competitive nature of the processes of retardation of hardening and acceleration of hardening of the cement system due to the nucleation effect, as a result of which the curve of the setting time is extreme. In addition, the inhibitory effect of sucrose reduces the strength of concrete on the 7th day. By the 28th day, the inhibitory effect of sucrose has been overcome, and concrete samples demonstrate an 18% increase in compressive strength with a sSCD content of 30%. The low content of residual free lactose in the composition of lSCD causes the nucleation effect. As a result, there is a monotonous reduction in the setting time of concrete mix with an increase in the content of lSCD in the composition of HF, as well as a significant increase in concrete strength (up to 127%) on the 7th day. At the same time, on the 28th day the strength of concrete increases slightly

You might also be interested in these eBooks
Innovations and Technologies in Construction View Preview

Info:

Periodical:

Materials Science Forum (Volume 1017)

Pages:

11-20

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.1017.11

Citation:

Cite this paper

Online since:

January 2021

Authors:

Evgeniy A. Shoshin, Valeria V. Strokova*, Zheng Mao Ye

Keywords:

Calcium Silicate Dispersion, Granulometry, Lactose, Modifying Carbohydrate, Setting Time, Strength of Cement Concrete, Sucrose

Export:

RIS, BibTeX

Price:

Permissions:

Request Permissions

* - Corresponding Author

References

[1] Bruno L. Damineli, Vanderley M. John, Björn Lagerblad, Rafael G. Pileggi, Viscosity prediction of cement-filler suspensions using interference model: A route for binder efficiency enhancement, Cement and Concrete Research, 84 (2016) 8–19.

DOI: 10.1016/j.cemconres.2016.02.012

Google Scholar

[2] O.A. Slyusar', V.M. Uvarov, Effect of Complex Additives on Ceramic Slip Mobility, Glass and Ceramics (English translation of Steklo i Keramika), 74 (3–4) (2017) 110–111.

DOI: 10.1007/s10717-017-9940-1

Google Scholar

[3] V.V. Strokova, L.N. Solovieva, Assessment of the influence of crystalline seeds on the structure formation of cement stone, Building materials, 3 (2009) 97–98.

Google Scholar

[4] Jeffrey W. Thomas, Hamlin M. Jennings, Jeffrey Chen, Influence of Nucleation Seeding on the Hydration Mechanisms of Tricalcium Silicate and Cement, Journal of Physical Chemistry C, 113 (2009) 4327–4334.

DOI: 10.1021/jp809811w

Google Scholar

[5] N.I. Kozhukhova, V.V. Strokova, M.I. Kozhukhova, I.V. Zhernovsky, Structure formation in alkali activated aluminosilicate binding systems using natural raw materials with different crystallinity degree, Construction Materials and Products, 1 (4) (2018) 38–43.

DOI: 10.34031/2618-7183-2018-1-4-38-43

Google Scholar

[6] Kieran Owens, Murat I. Russell, George Donnelly, Antony Kirk, Pam Basheer, Use of nanocrystal seeding chemical admixture in improving Portland cement strength development: application for precast concrete industry, Advances in Applied Ceramics, 113 (2014) 478–484.

DOI: 10.1179/1743676114y.0000000176

Google Scholar

[7] Anja Terzić, Lato Pezo, Nevenka Mijatović, Jovica Stojanović, Ljubiša Andrić, The effect of alternations in mineral additives (zeolite, bentonite, fly ash) on physico-chemical behavior of Portland cement based binders, Construction and Building Materials, 180 (2018) 199–210.

DOI: 10.1016/j.conbuildmat.2018.06.007

Google Scholar

[8] M.V. Wexler, Increasing the efficiency of cement compositions, introduction of mineral fillers, Technologies of concretes, concrete Technology, 7–8 (2010) 32–34.

Google Scholar

[9] Bruno Luis Damineli, Vanderley Moacyr John, Björn Lagerblad, Rafael Giuliano Pileggi, Viscosity prediction of cement-filler suspensions using interference model: A route for binder efficiency enhancement, Cement and Concrete Research, 84 (2016) 8–19.

DOI: 10.1016/j.cemconres.2016.02.012

Google Scholar

[10] A.A. Volodchenko, Influence of artificial calcium hydrosilicates on the hardening processes and properties of non-autoclave silicate materials based on unconventional aluminosilicate raw materials, Construction Materials and Products, 3 (2) (2020) 19–28.

DOI: 10.34031/2618-7183-2020-3-2-19-28

Google Scholar

[11] A.A. Volodchenko, V.S. Lesovik, A.A. Stoletov, E.S. Glagolev, A.N. Volodchenko, Z.G. Magomedov, Influence of man-made aluminosilicate raw materials on physical and mechanical properties of building materials, IOP Conference Series: Materials Science and Engineering, 327 (2) (2018) 022104.

DOI: 10.1088/1757-899x/327/2/022104

Google Scholar

[12] R. Alizadeh, L. Raki, J.M. Makar, J.J. Beaudoin, I. Moudrakovski, Hydration of tricalcium silicate in the presence of synthetic calcium-silicate-hydrate, J. Mater. Chem, 19 (2009) 7937–7946.

DOI: 10.1039/b910216g

Google Scholar

[13] H. Lindgreen, M. Geiker, H. Krøyer, N. Springer, J. Skibsted, Microstructure engineering of Portland cement pastes and mortars through addition of ultrafine layer silicates, Cement & Concrete Composites, 30 (2008) 686–699.

DOI: 10.1016/j.cemconcomp.2008.05.003

Google Scholar

[14] D.S. Gorev, V.V. Potapov, T.S. Goreva, Nanosilica based on hydrothermal solutions: characteristics, results of increasing the strength of fine-grained concrete, Modern high technology, 8 (2018) 54–58.

DOI: 10.17513/snt.37119

Google Scholar

[15] Wei Guan, Fangying Ji, Dexin Fang, Yong Cheng, Peng Yan, Porosity formation and enhanced solubility of calcium silicate hydrate in hydrothermal synthesis, Ceramics International, 40 (1) (2014) 1667–1674.

DOI: 10.1016/j.ceramint.2013.07.058

Google Scholar

[16] Yangyu Liu, Hongwei Jia, Guangxin Zhang, Zhiming Sun, Shuilin Zheng, Synthesis and humidity control performances of natural opoka based porous calcium silicate hydrate, Advanced Powder Technology, 30 (11) (2019) 2733–2741.

DOI: 10.1016/j.apt.2019.08.020

Google Scholar

[17] Lucie Galvánková, Jiří Másilko, Tomáš Solný, Eva Štěpánková, Tobermorite Synthesis Under Hydrothermal Conditions, Procedia Engineering, 151 (2016) 100–107.

DOI: 10.1016/j.proeng.2016.07.394

Google Scholar

[18] Gerrit Land, Dietmar Stephan, The effect of synthesis conditions on the efficiency of C-S-H seeds to accelerate cement hydration, Cement & Concrete Composites, 87 (2018) 73–78.

DOI: 10.1016/j.cemconcomp.2017.12.006

Google Scholar

[19] John Elisabeth, Matschei Thomas, Stephan Dietmar, Nucleation seeding with calcium silicate hydrate – A review, Cement and Concrete Research, 113 (2018) 74–85.

DOI: 10.1016/j.cemconres.2018.07.003

Google Scholar

[20] G. Land, D. Stephan, The effect of synthesis conditions on the efficiency of C-S-H seeds to accelerate cement hydration, Cement and Concrete Composites, 87 (2018) 73–78.

DOI: 10.1016/j.cemconcomp.2017.12.006

Google Scholar

[21] Z.Y. Qu, Q.L. Yu, H.J.H. Brouwers, Relationship between the particle size and dosage of LDHs and concrete resistance against chloride ingress, Cement and Concrete Research, 105 (2018) 81–90.

DOI: 10.1016/j.cemconres.2018.01.005

Google Scholar

[22] J. Plank, M. Schönlein, V. Kanchanason, Study on the early crystallization of calcium silicate hydrate (C-S-H) in the presence of polycarboxylate superplasticizers, J. Organomet. Chem, 968 (2018) 227–232.

DOI: 10.1016/j.jorganchem.2018.02.005

Google Scholar

[23] Е.A. Shoshin, Silicate filler obtained by thermolysis of modified cement hydrosilicates, Building materials, 7 (2017) 16–19.

Google Scholar

[24] Е.A. Shoshin, V.V. Strokova, Adsorption of mono- and disaccharides by Portland cement hydration products, Izvestiya SPbSTI, 49 (75) (2019) 58–64.

Google Scholar

[25] B.J. Smitha, A. Rawala, G.P. Funkhouser, L.R. Roberts, V. Gupta, J.N. Israelachvilia, B.F. Chmelka, Origins of saccharide-dependent hydration at aluminate, silicate, and aluminosilicate surfaces, PNAS, 108 (22) (2011) 8949–8954.

DOI: 10.1073/pnas.1104526108

Google Scholar

[26] E.A. Shoshin, A.V. Polyakov, Composition and structure of hydrosilicates obtained by mechanochemical synthesis from Portland cement modified with sucrose, Bulletin of BSTU after V.G. Shukhov, 1 (2018) 76–81.

DOI: 10.12737/article_5a5dbf0c0726d6.78718008

Google Scholar

Scientific.Net is a registered brand of Trans Tech Publications Ltd
© 2024 by Trans Tech Publications Ltd. All Rights Reserved