Abstract
Design of freeze-drying processes is often approached with a “trial and error” experimental plan or, worse yet, the protocol used in the first laboratory run is adopted without further attempts at optimization. Consequently, commercial freeze-drying processes are often neither robust nor efficient. It is our thesis that design of an “optimized” freeze-drying process is not particularly difficult for most products, as long as some simple rules based on well-accepted scientific principles are followed. It is the purpose of this review to discuss the scientific foundations of the freeze-drying process design and then to consolidate these principles into a set of guidelines for rational process design and optimization. General advice is given concerning common stability issues with proteins, but unusual and difficult stability issues are beyond the scope of this review. Control of ice nucleation and crystallization during the freezing step is discussed, and the impact of freezing on the rest of the process and final product quality is reviewed. Representative freezing protocols are presented. The significance of the collapse temperature and the thermal transition, denoted T g`, are discussed, and procedures for the selection of the “target product temperature” for primary drying are presented. Furthermore, guidelines are given for selection of the optimal shelf temperature and chamber pressure settings required to achieve the target product temperature without thermal and/or mass transfer overload of the freeze dryer. Finally, guidelines and “rules” for optimization of secondary drying and representative secondary drying protocols are presented.
Similar content being viewed by others
references
M. J. Pikal. Freeze-drying of proteins. Part I: process design. BioPharm 3:18-28 (1990).
M. J. Pikal. Freeze-drying of proteins part II: formulation selection. BioPharm 3:26-30 (1990).
M. J. Pikal. Freeze-Drying of Proteins. In V. H. L. Lee (ed.), Peptide and Proteins Delivery, Marcel Dekker, New York, 1998.
J. F. Carpenter and B. S. Chang. Lyophilization of protein pharmaceuticals. In K. Avisand and V. Wu (eds.), Biotechnology and Biopharmaceutical Manufacturing, Processing and Preservation, Intepharm Press, Buffalo Grove, IL, 1996, pp. 199-263.
J. M. Beals, M. J. Edwards, M. J. Pikal, and J. V. Rinella, Jr. Formulations of obesity protein, Eur. Pat. Appl. (Eli Lilly and Co., USA). EP, 1997, pp. 48
S. L. Nail and L. A. Gatin. Freeze-drying: principles and practice. In K. E. Avis, H. A. Lieberman, and L. Lechman (eds.), Pharmaceutical Dosage Forms: Parenteral Medications, Vol. 2, Marcel Dekker, New York, 1993, pp. 163-233.
F. Franks. Freeze drying: from empiricism to predictability. Cryo-Letters 11:93-110 (1990).
J. F. Carpenter, M. J. Pikal, B. S. Chang, and T. W. Randolph. Rational design of stable lyophilized protein formulations: some practical advice. Pharm. Res. 14:969-975 (1997).
A. P. Mackenzie. Basic principles of freeze-drying for pharmaceuticals. Bull. Parenter. Drug Assoc. 20:101-130 (1966).
M. J. Pikal and S. Shah. The collapse temperature in freeze drying: dependence on measurement methodology and rate of water removal from the glassy phase. Int. J. Pharm. 62:165-186 (1990).
E. Y. Shalaev and F. Franks. Changes in the physical state of model mixtures during freezing and drying: impact on product quality. Cryobio. 33:14-26 (1996).
P. L. Privalov. Cold denaturation of proteins. Crit. Rev. Biochem. Mol. Biol. 25:281-305 (1990).
Y. V. Griko, S. Y. Venyaminov, and P. L. Privalov. Heat and cold denaturation of phosphoglycerate kinase (interaction of domains). FEBS Lett. 244:276-278 (1989).
B. S. Chang, B. S. Kendrick, and J. F. Carpenter. Surface-induced denaturation of proteins during freezing and its inhibition by surfactants. J. Pharm. Sci. 85:1325-1330 (1996).
J. F. Carpenter, S. J. Prestrelski, and T. Arakawa. Separation of freezing-and drying-induced denaturation of lyophilized proteins using stress-specific stabilization. I. Enzyme activity and calorimetric studies. Arch. Biochem. Biophys. 303:456-464 (1993).
M. J. Pikal. Lyophilization. In J. Swarbrick and J. Boylan (eds.), Encyclopedia of Pharmaceutical Technology, Marcel Dekker, New York, 2002, pp. 1299-1326.
N. Murase and F. Franks. Salt precipitation during the freeze-concentration of phosphate buffer solutions. Biophys. Chem. 34:293-300 (1989).
B. A. Szkudlarek, T. J. Anchordoquy, G. A. Garcia, M. J. Pikal, J. F. Carpenter, and N. Rodriguez-Hornedo. pH changes of phosphate buffer solutions during freezing and their influence on the stability of a model protein, lactate dehydrogenase, Book of Abstracts, 211th ACS National Meeting, New Orleans, LA, 1996, pp. BIOT-138.
E. Shalaev, T. Johnson-Elton, L. Change, and M. J. Pikal. Thermophysical properties of pharmaceutically compatible buffers at sub-zero temperatures: implications for freeze drying. Pharm. Res. 19:195-211 (2002).
S. Jiang and S. L. Nail. Effect of process conditions on recovery of protein activity after freezing and freeze-drying. Eur. J. Pharm. Biopharm. 45:249-257 (1998).
J. A. Searles, J. F. Carpenter, and T. W. Randolph. The ice nucleation temperature determines the primary drying rate of lyophilization for samples frozen on a temperature-controlled shelf. J. Pharm. Sci. 90:860-871.
M. C. Heller, J. F. Carpenter, and T. W. Randolph. Protein formulation and lyophilization cycle design: prevention of damage due to freeze-concentration induced phase separation. Biotechnol. Bioeng. 63:166-174 (1999).
M. C. Heller, J. F. Carpenter, and T. W. Randolph. Application of a thermodynamic model to the prediction of phase separations in freeze-concentrated formulations for protein lyophilization. Arch. Biochem. Biophys. 363:191-201 (1999).
K-I. Izutsu, S. Yoshioka, and S. Kojima. Phase separation and crystallization of components in frozen solutions: effect of molecular compatibility between solutes. ACS Symp. Ser. 675:109-118 (1997).
B. Lueckel, D. Bodmer, B. Helk, and H. Leuenberger. Formulations of sugars with amino acids or mannitol-influence of concentration ratio on the properties of the freeze-concentrate and the lyophilizate. Pharm. Dev. Technol. 3:325-336 (1998).
N. A. Williams. Y. Lee, G. P. Polli, and T. A. Jennings. The effects of cooling rate on solid phase transitions and associated vial breakage occurring in frozen mannitol solutions. J. Parenter. Sci. Technol. 40:135-141 (1986).
A. Pyne, R. Surana, and R. Suryanarayanan. Crystallization of mannitol below Tg′ during freeze-drying in binary and ternary aqueous systems. Pharm. Res. 19:901-908 (2002).
M. J. Pikal, S. Shah, D. Senior, and J. E. Lang. Physical chemistry of freeze-drying: measurement of sublimation rates for frozen aqueous solutions by a microbalance technique. J. Pharm. Sci. 72:635-650 (1983).
J. A. Searles, J. F. Carpenter, and T. W. Randolph. Annealing to optimize the primary drying rate, reduce freezing-induced drying rate heterogeneity, and determine Tg′ in pharmaceutical lyophilization. J. Pharm. Sci. 90: 872-887.
M. J. Pikal, S. Shah, M. L. Roy, and R. Putman. The secondary drying stage of freeze drying: drying kinetics as a function of temperature and chamber pressure. Int. J. Pharm. 60:203-217 (1990).
R. P. Bhattacharyya and T. R. Sosnick. Viscosity dependence of the folding kinetics of a dimeric and monomeric coiled coil. Biochem. 38:2601-2609 (1999).
H. A. Kramers. Brownian motion in a field of force and the diffusion model of chemical reactions. Physica 7:284-304 (1940).
X. Ma, D. Q. Wang, R. Bouffard, and A. MacKenzie. Characterization of murine monoclonal antibody to tumor necrosis factor (TNF-MAb) formulation for freeze-drying cycle development. Pharm. Res. 18:196-202 (2001).
M. J. Pikal. Mechanisms of protein stabilization during freeze-drying and storage: the relative importance of thermodynamic stabilization and glassy state relaxation dynamics. Drugs Pharm. Sci. 96:161-198 (1999).
M. J. Pikal and J. E. Lang. Rubber closures as a source of haze in freeze dried parenterals: test methodology for closure evaluation. J. Parenter. Drug Assoc. 32:162-173 (1978).
M. J. Pikal, M. L. Roy, and S. Shah. Mass and heat transfer in vial freeze-drying of pharmaceuticals: role of the vial. J. Pharm. Sci. 73:1224-1237 (1984).
N. Milton, M. J. Pikal, M. L. Roy, and S. L. Nail. Evaluation of manometric temperature measurement as a method of monitoring product temperature during lyophilization. PDA J. Pharm. Sci. Technol. 51:7-16 (1997).
X. C. Tang, S. L. Nail, and M. J. Pikal. Mass transfer in freeze drying: measurement of dry layer resistance by a non-steady state method (the MTM procedure). 1999 AAPS Anual Meeting, New Orleans, Louisiana, 1999.
X. C. Tang, S. L. Nail, and M. J. Pikal. Freeze drying process optimization by manometric temperature measurement, 2001 AAPS Annual Meeting, Denver, Colorado, 2001.
M. J. Pikal. Use of laboratory data in freeze drying process design: heat and mass transfer coefficients and the computer simulation of freeze drying. J. Parenter. Sci. Technol. 39:115-139 (1985).
M. L. Roy and M. J. Pikal. Process control in freeze drying: determination of the end point of sublimation drying by an electronic moisture sensor. J. Parenter. Sci. Technol. 43:60-66 (1989).
M. J. Pikal, K. M. Dellerman, and M. L. Roy. Formulation and stability of freeze-dried proteins: effects of moisture and oxygen on the stability of freeze-dried formulations of human growth hormone. Develop. Bio. Standard. 74:21-38 (1991).
M. J. Hageman. The role of moisture in protein stability. Drug Dev. Ind. Pharm. 14:2047-2070 (1988).
M. S. Kamat, R. A. Lodder, and P. P. DeLuca. Near-infrared spectroscopic determination of residual moisture in lyophilized sucrose through intact glass vials. Pharm. Res. 6:961-965 (1989).
I. Presser, N. Denkinger, H. Hormann, and G. Winter. New methods in monitering of freeze-drying: near-infrared spectroscopy determination of residue moiture during freeze-drying, 2002 Protein Stability Conference, Breckenridge, Colorado, 2002.
E. Maltini. Estimation of the viscosities of the frozen sucrose-water system from glass transition temperatures. Ita. J. Food Sci. 4:371-377 (1993).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Tang, X.(., Pikal, M.J. Design of Freeze-Drying Processes for Pharmaceuticals: Practical Advice. Pharm Res 21, 191–200 (2004). https://doi.org/10.1023/B:PHAM.0000016234.73023.75
Issue Date:
DOI: https://doi.org/10.1023/B:PHAM.0000016234.73023.75