Chapter 2 - Notes on useful materials and synthesis through various chemical solution techniques
References (0)
Cited by (8)
Morphology dependent negative dielectric permittivity in spinel ferrite nanostructures
2024, Journal of Alloys and CompoundsThe effect of sulfur precursor on the morphology, properties and formation mechanism of chemical bath deposited Pb<inf>1+x</inf>S thin solid films
2023, Materials Chemistry and PhysicsEffect of heat treatment on coupled magnetostructural transition and magnetocaloric effect of MnNiGe system
2023, Journal of Magnetism and Magnetic MaterialsMagnetic field stimulated dielectric, electronic and thermal properties of magnetite nano-hollow spheres based magnetorheological fluids
2023, Journal of Magnetism and Magnetic MaterialsCitation Excerpt :Finally, the improvement in magnetic field stimulated heat transfer property through the MR fluids along with direction-controlled thermal conduction is presented. Fe3O4 NHSs were synthesized in a solvothermal method as reported earlier[31,32]. In the typical synthesis, 1.015 g of FeCl3·6H2O and 0.465 g of urea were dissolved in 30 ml Ethylene glycol, and stirred until clear homogeneous solution was obtained.
Photocatalytic water splitting performance of TiO<inf>2</inf> sensitized by metal chalcogenides: A review
2022, Ceramics InternationalCitation Excerpt :In this work, GQDs also enhanced charge carrier separation and facilitated surface reaction kinetics, which results in increased PEC efficiency [137–139]. Most TMCs have a smaller bandgap than TiO2 [140]. According to Krbal et al. (2017), coupling low band gap TMC nanocrystals with a wide band gap metal oxide surface could improve broadband light absorption, charge separation/transport, and photoanode efficiency [4].
Electrochemical and optical sensors made of composites of metal–organic frameworks and carbon-based materials. A review
2022, Environmental Chemistry Letters