Theoretical progress in polymer adsorption, steric stabilization and flocculation

https://doi.org/10.1016/0166-6622(88)80178-1Get rights and content

Abstract

The range of validity of scaling and mean field models for polymers at interfaces is discussed. According to a recent analysis by Schaefer, mean field theories describe the properties of polymers in solution correctly over a wider range of concentration and solvency than does scaling. Only for flexible polymers in very good solvents at concentrations below a few percent are scaling methods preferred. In polymer adsorption, high segment densities occur and therefore mean field theories are more appropriate than scaling.

The most detailed mean field theory for polymers at interfaces has been proposed by Scheutjens and Fleer. The distribution of segments as a function of ranking number and, consequently, end effects (tails) are taken fully into account. Several results are given for adsorbing and nonadsorbing polymers at a surface and for the effect of polymers on colloidal stability (bridging, steric stabilization and depletion flocculation). In some cases, a comparison with the outcome of other theories is made. Experimental results, available so far, corroborate the main predictions.

References (53)

  • D.W. Schaefer

    Polymer

    (1984)
  • G.J. Fleer et al.

    J. Colloid Interface Sci.

    (1986)
  • F.A.M. Leermakers et al.

    6th Int. Symposium on Surfactants in Solution, New Dehli

    (1986)
  • C.Vander Linden et al.

    J. Colloid Interface Sci.

    (1978)
  • M. Kawaguchi et al.

    Polym. J.

    (1980)
  • J. Klein et al.

    Nature (London)

    (1984)
  • H. de Hek et al.

    J. Colloid Interface Sci.

    (1981)
  • J.F. Joanny et al.

    J. Polym. Sci.

    (1979)
  • R.I. Feigin et al.

    J. Colloid Interface Sci.

    (1981)
  • P.J. Flory
    (1953)
  • P.G. de Gennes
    (1979)
  • M. Daoud et al.

    Macromolecules

    (1975)
  • A. Lapp et al.

    J. Phys. Lett.

    (1985)
  • P.G. de Gennes

    Macromolecules

    (1980)
  • P.G. de Gennes

    Macromolecules

    (1981)
  • C.A.J. Hoeve

    J. Polym. Sci.

    (1970)
  • A.K. Dolan et al.

    Proc. R. Soc. London

    (1974)
    A.K. Dolan et al.

    Proc. R. Soc. London

    (1975)
  • I.S. Jones et al.

    J. Chem. Soc. Faraday Trans. 2

    (1977)
  • P.R. Gerber et al.

    Macromolecules

    (1977)
  • A. Silberberg

    J. Chem. Phys.

    (1968)
  • R.J. Roe

    J. Chem. Phys.

    (1974)
  • J.M.H.M. Scheutjens et al.

    J. Phys. Chem.

    (1979)
  • J.M.H.M. Scheutjens et al.

    J. Phys. Chem.

    (1980)
  • J.M.H.M. Scheutjens et al.

    Macromolecules

    (1985)
  • E.A. DiMarzio et al.

    J. Chem. Phys.

    (1971)
  • J.M.H.M. Scheutjens et al.

    Colloids Surfaces

    (1986)
  • Cited by (95)

    • Adsorption of Polyvinylpyrrolidone and its Impact on Maintenance of Aqueous Supersaturation of Indomethacin via Crystal Growth Inhibition

      2015, Journal of Pharmaceutical Sciences
      Citation Excerpt :

      The parameters of the Langmuir adsorption isotherm model (Table 1) including the Langmuir constant (K) and the maximum amount adsorbed (Amax) describe the affinity of the adsorbate for a specific adsorbent and the adsorption capacity of the adsorbent, respectively. The polymer adsorption process depends on several factors including the nature of the polymer, solvent, and the surface of the adsorbent.35–37 The adsorption behavior of a polymer could be influenced by the adsorption energy and related intermolecular polymer–solvent, solvent–surface, and polymer–surface interactions such as van der Waals, electrostatic, hydrogen bonding, and hydrophobic interactions.1,38,39

    • Adsorption of poly(hydroxystearic acid) to TiO<inf>2</inf> nanoparticles, studied using gel permeation chromatography

      2015, Colloids and Surfaces A: Physicochemical and Engineering Aspects
      Citation Excerpt :

      As seen in the insets in Figs. 2 and 3, the Langmuir isotherm fits quite well with the experimental data for all dispersants in both solvents (R2 > 0.99). The adsorbed amount is a function of molecular weight (and in the case of the oligermerics, molecular weight distribution), solubility in the solvent (and therefore relative solubility parameters) characterised by the Flory Huggins interaction parameter χ, affinity for the surface of the adsorbing functional group(s), and repulsion from the solvent of this functional group [17,18]. The adsorption mechanism of all three dispersants is likely to be similar: they are all fatty acids with a single terminal acid group which can interact with hydroxyl groups at the metal oxide surface; fatty chains extend into the solvent to provide stability.

    • Scattering approaches to probing surface layers under confinement

      2015, Current Opinion in Colloid and Interface Science
      Citation Excerpt :

      The wide range of applications for adsorbed polymers has made these systems highly desirable subjects for confinement investigations, and a wealth of SFA and AFM force measurements underpin understanding in this field. Partnered with the experimental characterization of adsorbed polymers, the theoretical framework of Scheutjens–Fleer theory [18] provides a model to describe the polymer volume fraction profile in a solvent; this lattice model makes experimentally verified predictions for the volume fraction profiles [19–21] with NMR, small-angle neutron scattering (SANS), and neutron reflection playing important roles. In probing the adsorbed polymers with neutron reflection, a significant technical limitation must be considered: a large neutron beam footprint (500 to [2500] mm2) is required in order to finish one experiment in a reasonable time frame [7].

    • Layer-by-layer assembly of iron oxide magnetic nanoparticles decorated silica colloid for water remediation

      2014, Chemical Engineering Journal
      Citation Excerpt :

      The presence of PDDA polyelectrolyte on the outmost layer of silica colloids caused a reversal of zeta potential to +58.3 mV. On top of that, the orientation of the adsorbed polyelectrolyte on silica particle surface is most probably appeared as trains, loops and tails which has been well-investigated by the Fleer’s group [53,54]. This adsorbed layer of cationic PDDA serves as the binding agent to facilitate the attachment of negatively charged IOMNPs with zeta potential at −6.6 mV.

    View all citing articles on Scopus
    View full text