Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Abbreviations
- Alternating current (AC):
-
Usually in the form of a sine wave, the bidirectional current flow continually reverses. Typically, AC will have a zero mean (average) and a nonzero RMS value. In the USA, most “grid” electricity is generated and distributed in the form of 60 Hz sinusoidal waveform. In other areas of the world, 50 Hz is commonly used.
- Amp-hour (Ah):
-
A unit of electric charge, the amount of current delivered for 1 hour.
- Battery:
-
A group of one or more cells electrically connected in series and/or parallel combinations to achieve higher voltage or current than what is capable from a single cell.
- Battery management system (BMS):
-
An electronic device or system that monitors and controls a rechargeable battery. Parameters measured may include cell temperature, voltage, and current. From this data, the BMS can compute the state of charge of the battery and estimate the state of health, remaining cycle lives, or remaining service life. Typically, a BMS system will include the ability to communicate with a host system and battery charger. The BMS may also contain sensors and circuitry for protection such as over-current, over-temperature, or over-voltage.
- Battery pack:
-
A group of batteries or individual cells electrically connected in series and/or parallel combinations along with the required electrical interconnections, mechanical packaging, thermal management, and sensing circuitry. Because it is a self-contained assembly, a battery pack can be easily swapped in and out of the application.
- Battery string:
-
Series-connected batteries used to produce a higher voltage. The same current passes through all the cells, but each cell voltage can vary. Charge balancing becomes a significant issue for a long string of 50 or more cells.
- C-rate:
-
The rate at which a battery can deliver or accept current, stated in terms of the rated capacity of the cell in amp-hours. This may also be referred to as the hour rate, such as the 1-h rate.
- Cell:
-
An individual electrochemical device that converts between chemical energy and electrical energy. The cell construction, open circuit voltage, energy, and power density, all depend on the chemistry of the cell (see section “Battery Chemistries”).
- Coulombic efficiency:
-
Ratio of charge delivered by a rechargeable battery during discharge cycle to the charge stored during charge cycle.
- Depth of discharge (DoD):
-
An alternate method to indicate the state of charge of the battery; it is the reciprocal of SoC.
- Direct current (DC):
-
Unidirectional current that continually flows only in one direction. Sources such as batteries, fuel cells, and solar cells produce electricity in the form of direct current.
- Memory effect:
-
An effect observed particularly in nickel cadmium batteries in which the cells gradually lose capacity when subject to repeated partial discharges followed by complete recharges cycles. This electrochemical effect is different than the loss of capacity due to aging and use. In some cases, a series of full discharge/recharge cycles can restore some or all of the lost capacity due to the memory effect but not due to cycle life or aging.
- Proportional-integral (PI) controller:
-
A type of linear feedback control in which an error signal is calculated as the difference between a measured signal and the desired reference set point. The controller attempts to adjust the operation of the process using a weighted combination of the present error (proportional term) and accumulated past error (integral term).
- Primary battery:
-
One-time-use batteries not capable of being recharged. They are discarded or preferably recycled once the stored energy has been depleted. These types of batteries will not be considered in this article.
- Root mean square (RMS):
-
A scalar quantity that is computed from the square root of the sum of the squares of a dataset and is commonly used to represent a voltage or current over one cyclical period. Average power is the product of the RMS current and RMS voltage.
- Secondary battery:
-
Commonly referred to as rechargeable batteries, they can be repeatedly recharged electrically by passing current through them in the opposite direction to that of the discharge current. Secondary batteries are of significant interest for their ability to store and supply energy and are the focus of this article.
- Self-discharge rate:
-
The rate at which a battery discharges, or looses stored energy, due to internal cell reactions.
- SLI batteries:
-
Starting, lighting, and ignition (SLI) batteries are used in automobiles. These batteries are usually characterized by a high discharge rate.
- State of charge (SoC):
-
Defined as the capacity left in a battery expressed as a percentage of some reference. SoC of a battery is usually expressed as a percentage of the current battery capacity when it is fully charged.
- State of health (SoH):
-
A metric that reflects the general condition of a battery and its ability to deliver the specified performance compared with a fresh battery. It takes into account factors such as charge acceptance, internal resistance, voltage, and self-discharge. It is an estimate rather than a measurement.
- Watt-hour (Wh):
-
A unit of energy, the amount of power delivered for 1 h. It is equivalent to 3,600 Joules of energy.
Bibliography
Aditya JP, Ferdowsi M (2008) Comparison of NiMH and Li-Ion batteries in automotive applications. In: Proceedings, IEEE vehicle power and propulsion conference. IEEE, Piscataway
Available online: http://www.eetimes.com/electronics-news/4196006/Analyst-Super-capacitor-aided-wireless-charging-the-key-to-powering-mobiles
Available online: http://www.technology.am/wireless-charging-022522.html
Available online: http://www.wired.com/autopia/2010/11/ditch-the-cord-let-the-road-charge-your-ev/
Available online: http://www.wired.com/autopia/2011/03/google-installs-a-wireless-ev-charging-station/
Barnes FS, Levine JG (2011) Large energy storage systems handbook. CRC Press, Boca Raton
Beart P, Cheng L, Hay J (2006) Inductive energy transfer system having a horizontal magnetic field. UK Patent GB2,399,225
Bito A (2005) Overview of the sodium-sulfur battery for the IEEE stationary battery committee. In: Proceedings, IEEE power engineering society general meeting. IEEE, Piscataway, p 1232
Bullis K (2009) High-energy batteries coming to market: rechargeable zinc-air batteries can store three times the energy of a lithium-ion battery. http://www.technologyreview.com/business/23812/
Chia-Hsiang L, Chun-Yu H, Ke-Horng C (2010) A li-ion battery charger with smooth control circuit and built-in resistance compensator for achieving stable and fast charging. IEEE Trans Circuits Syst 57(2):506–517
Cong-Ling H, Jie W, Miao Z, Jin-Ming Y, Jin-Peng L (2004) Application of adaptive algorithm of solar cell battery charger. In: Proceedings of the 2004 IEEE international conference on electric utility deregulation, restructuring and power technologies (vol 2). IEEE, Piscataway, pp 810–813
Cope RC, Podrazhansky Y (1999) The art of battery charging. Battery conference on applications and advance, the fourteenth annual, California, pp 233–235
Crompton TR (1995) Battery reference book, 2nd edn. Butterworth-Heinemann Ltd, Oxford/Boston
Hua CC, Lin MY (2000) A study of charging control of lead-acid battery for electric vehicles. Industrial electronics ISIE, proceedings of the 2000 IEEE international symposium (vol 1), Puebla, pp 135–140
Hua CC, Lin MY (2000) A study of charging control of lead-acid battery of electric vehicles. IEEE proceedings. of ISIE (vol 1), Dallas, pp 135–140
Hui SYR (2006) Planar inductive battery charger. UK Patent GB238,972
IEEE Std 519 (2009) IEEE recommended practices and requirements for harmonic control in electrical power systems. IEEE, New York
Jaganathan SH (2009) Battery charging power electronics and control for plug-in hybrid electric vehicle. Thesis, Tennessee Technological University, pp 94–103
Kamibayashi M, Tanaka K (2001–2002) Recent sodium sulfur battery applications. In: IEEE transmission and distribution conference and exposition (vol 2). IEEE/PES, Atlanta, pp 1169–1173
Köhler U, Kümpers J, Ullrich M (2002) High performance nickel-metal hydride and lithium-ion batteries. J Power Sourc 105:139–144
Kiehne HA (2007) Battery technology handbook, 2nd edn. Chapter 12, Charging methods and techniques: general requirements and selection of chargers, Dekker
Kline M (2010) Capacitive power transfer. M.S. thesis, Department of Electrical Eng. and Computer Science, University of California, Berkeley
Kodali VP (1996) Engineering electromagnetic compatibility. IEEE Press, New York, pp 345–348
Koenig AA, Rasmussen JR (1990) Development of a high specific power sodium sulfur cell. In: Proceedings IEEE 34th international power sources symposium, Cherry Hill, pp 30–33
Krein PT, Balog RS (2002) Life extension through charge equalization of lead–acid batteries. In: Proceedings, IEEE international telecommunications energy conference (INTELEC). IEEE, Piscataway, pp 516–523
Kuhn BT, Pitel GE, Krein PT (2005) Electrical properties and equalization of lithium-ion cells in automotive applications. In: Proceedings, IEEE vehicle power and propulsion conference. IEEE, Piscataway, p 5
LeFevre BW (2003) Integrated microbattery charger for autonomous systems. Birgham Young University, Provo
Lex P, Jonshagen B (1999) The zinc/bromine battery system for utility and remote area applications. Power Eng J 13:3
Li P, Bashirullah R (2010) A wireless power interface for rechargeable battery operated medical implants. IEEE Trans Circuits Syst 54(10):912–916
Liawt CM, Chiangt SJ, Huang SC (1994) A three-phase multi-functional battery energy storage system. Proceedings of IECON 94 Conference. IEEE, New York, pp 458–463
Linden D, Reddy TB (2002) Handbook of batteries, 3rd edn. McGraw-Hill, New York
Liu X, Ron Hui SY (2007) Equivalent circuit modeling of a multilayer planar winding array structure for use in a universal contactless battery charging platform. IEEE Trans Power Electron 22(1):21–29
Marshman C (1992) Guide to the EMC directive. 89/336/EEC. IEEE Press, Piscataway
Mohan N, Undeland TM, Robbins WP (2003) Power electronics converters, applications and design, 3rd edn. Wiley, New York
Montrose MI (1996) Printed circuit design techniques for emc compliance. IEEE Press, New York
Moore SW, Schneider PJ (2001) A review of cell equalization methods for lithium ion and lithium polymer battery systems. SAE Technical Paper Series. pp 1–5
Morrow K, Karner D, Francfort J (2008) Plug in hybrid electric vehicle charging infrastructure review. US department of energy vehicle technologies program – advanced vehicle testing activity. Battelle Energy Alliance, The Idaho National Laboratory
Palanisamy T (1990) Charging techniques for a universal lead-acid battery charger. Proceedings of the 34th international power sources symposium. IEEE, New York, pp 72–76, 25–28
Plett G (2002) Kalman-Filter soc estimation for LipbHev cells. In: Proceedings of the 19th international battery, hybrid and fuel cell electric vehicle symposium & exhibition (EVS19). Busan, pp 19–23
Poon NK, Pong MH, Tse CK (2003) A constant-power battery charger with inherent soft switching and power factor correction. IEEE Trans Power Electron 18(6):1262–1269
Pop V, Bergveld H, Notten P, Regtien P (2005) State-of-the-art of battery state-of-charge determination. Meas Sci Technol 16(12):93–110
Rashid MH (2006) Power electronics handbook, 2nd edn. Academic, California
Redl R (1996) Power electronics and electromagnetic compatibility. Power electronics specialists conference, PESC '96 record. 27th annual IEEE (vol 1). IEEE, New York, pp 15–21, 1:23–27
Tamyurek B, Nichols DK, Demirci O (2003) The NAS battery: a multifunction energy storage system. In: Proceedings IEEE power engineering society general meeting (vol 4). IEEE, Piscataway, pp 1991–1996
Tamyurek B, Nichols DK, Vollkommer HT (2003) Sodium sulfur battery applications. In: Proceedings IEEE power engineering society general meeting (vol 4). IEEE, Piscataway, pp 2323–2324
Vrankovic Z, Abedini AZ, Nasiri A (2007) A novel battery charger for automotive applications. IEEE conference of PESC’07. IEEE, Piscataway, pp 1465–1470
Wiesener K, Ohms D, Benczúr-Ürmössy G et al (1999) High power metal hydride bipolar battery. J Power Sourc 84(2):248–258
Zhi-Guo K, Chun-Bo Z, Ren-Gui L, Shu-Kang C (2006) Comparison and evaluation of charge equalization technique for series connected batteries. In: Record, IEEE 37th IEEE power electronics specialists conference (PESC), Jeju, pp 1–6
Author information
Authors and Affiliations
Corresponding author
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 2013 Springer Science+Business Media New York
About this entry
Cite this entry
Balog, R.S., Davoudi, A. (2013). Batteries, Battery Management , and Battery Charging Technology . In: Ehsani, M., Wang, FY., Brosch, G.L. (eds) Transportation Technologies for Sustainability. Springer, New York, NY. https://doi.org/10.1007/978-1-4614-5844-9_822
Download citation
DOI: https://doi.org/10.1007/978-1-4614-5844-9_822
Published:
Publisher Name: Springer, New York, NY
Print ISBN: 978-1-4614-5843-2
Online ISBN: 978-1-4614-5844-9
eBook Packages: EnergyReference Module Computer Science and Engineering